Modena RX Series Manual page 19

additional double switch according to the standard, which ensures disconnection of the power
source in case of conditions associated with excess flow category III.
-
The failure to follow these instructions may cause the electric shock, fire, or other hazards which
are fatal.
-
Before usage make sure the power cable has been installed properly.
-
If the power cord is damaged contact service center MODENA for improvement.
INSTALLATION (slim hood)
Suction hood can be mounted on a concrete wall (wall) or at the bottom of the wall cabinets kitchen
set.
Installation at the concrete wall (wall)
-
Make the center line on the wall where it will be placed suction hood.
-
If it is included, attach the template H to drill on the wall. Or otherwise has templates, attach the
suction hood on the wall and mark the holes to make the center hole spacing reference rear
suction hood.
Attention :
-
Before drilling, make sure no cable installation, water pipes and other installations in the wall.
-
Drill the wall then input fisher J into the hole.
-
Install the screws K on both the top and leaving a hole distance of 1 cm between the screw head
and the wall surface.
-
Attach the hood on the wall that has been installed screws by means of a suction hood hanging
on the screws.
-
If the position of the hood on the wall is correct, tighten the two screws using the locking L.
-
Then close the grid.
-
Connect sewer with spigot / Flange if suction hood will function for the system ducting / exhaust.
Installation at the bottom of the kitchen cabinet set
- Place the suction hood on the bottom of the kitchen cabinet set in accordance with the planned
position precisely.
- Make a sign at the bottom of the kitchen cabinet set for flexible pipe hole and then to back hole if
would use a suction hood ducting system / exhaust. Drill 4 holes at the corresponding position.
Posting spigot / flange and attach the suction hood and fasten with 4 screws M at position has
been prepared.
How to work
MODENA suction hood has two (2) versions of the workings of the system of DUCTING / EXHAUST
recirculating systems:
A. DUCTING / EXHAUST SYSTEM:
-
In this version, the suction hood works by sucking fumes / smoke aroma of cooking which then
are thrown out through sewer.
-
The hood has two air duct out to throw the smoke of suction. Channel air out the top of the B1
and the air duct out optional back panel B2 *.
-
Required system ducting heat resistant / fire for removing smoke / scent through the outlet.
-
To connect the suction hood with sewer use "spigot / Flange" C which have been provided on
each package suction hood.
-
Be sure to close the unused hole duct with cover D *.
-
In some models the upper hole B1 is closed, press firmly to release the part that closes the outlet
hole.
16
English