Operation
setting.
Cancel Password
Enter the command UNIT CONFIG > SET PASSWORD. Entering four
blanks will clear the password. Please refer to section Lock the Console to
enter a password.
In Case You Forget the Password
In case the password is forgotten and the super password (see Super PSW.) is
disabled, the following steps must be taken to reset the date including
password.
1. Power down (turn OFF the power).
2. Open the upper case.
3. Put a jumper on (indicated "Factory Reset" beside the
jumper).
4. Power up (turn ON the power).
5. After the Power On Self-Test messages complete, you
will see the message "DATA CLEAR" and then
"POWER DOWN".
6. Power down.
7. Remove the Factory Reset jumper.
8. Power up again, the system data should be reset to the
factory settings.
Super PSW
The Super Password is useful in case you are locked out of the system (your
password is forgotten).
FSD-1020 User's Manual
3-25