1. Package Contents Check the following contents of your package: FSD-504HP User’s Manual 51V Power Adapter Foot Pad Power Cord If any of these are missing or damaged, please contact your dealer immediately; if possible, retain the carton including the original packing material, and use them again to repack the product in case there is a need to return it to us for repair.
2. Product Features RJ45 Interface Five 10/100Mbps Fast Ethernet ports 4 ports support 51V DC power to PoE powered device Power over Ethernet Complies with IEEE 802.3af/at Power over Ethernet end-span + mid-span PSE Up to 4 IEEE 802.3af/2 IEEE 802.3at devices powered ...
Page 4
Switching Hardware based 10/100Mbps auto-negotiation and auto MDI/MDI-X Flow control for full duplex operation and back pressure for half duplex operation 1536bytes packet size support Integrates address look-up engine, supporting 1K absolute MAC addresses Automatic address learning and address aging ...
4. LED Indicators System Color Function Light: Indicates the Switch has Orange power. Per 10/100Mbps Port Color Function Lights to indicate the port is Orange providing 51V DC in-line power to remote PoE PD. Lights to indicate the link through that port is successfully established at 10/100Mbps.
Figure 5-1 shows the rear panel of FSD-504HP. 51V DC Standard Extend Figure 5-1: FSD-504HP Rear Panel The front panel of FSD-504HP provides one DIP switch for “Standard” and “Extend” mode selections. The detailed descriptions are shown in the following table. DIP Switch Function...
Page 8
Notice 2. In some area, installing a surge suppres- sion device may also help to protect your FSD-504HP from being damaged by un- regulated surge or current to the FSD- 504HP or the power adapter. - 7 -...
6. Installing the Switch This part describes how to install your FSD-504HP and make connections to it. Please read the following topics and follow the procedures as presented. This FSD-504HP does not need software configuration. Note Desktop Installation To install the FSD-504HP on desktop, simply follow the...
Page 10
B. Connect the other end of the cable to the network devices such as routers, Ethernet switches or NVRs (network video recorders). Step 4: Connect your FSD-504HP to PoE PD devices. A. Connect one end of a standard network cable to any of the four 10/100Mbps RJ45 PoE+ ports (Port 1 to Port 4).
Page 11
While a Category 3 or 4 cable may initially seem to work, it will soon cause data loss. Step 5: Supply power to the FSD-504HP. A. Connect one end of the power cable to the Switch.
Page 12
Step 2: Please refer to the picture below to screw the two screws on the wall. 80mm Step 3: Hang the FSD-504HP on the screws from the wall. Step 4: Repeat step 5 of Desktop Installation for power supply to the FSD-504HP.
7. Product Specifications FSD-504HP Model 4-Port 10/100Mbps 802.3af/at PoE + 1-Port 10/100Mbps Desktop Switch Hardware Specifications Hardware Version 5-Port RJ45 for 10/100BASE-TX, auto Network Connector MDI/MDIX 4-Port with 802.3af/at PoE injector PoE Inject Port function (Port 1 to port 4)
Page 14
Power over Ethernet IEEE 802.3af Power over Ethernet/PSE PoE Standard IEEE 802.3at Power over Ethernet Plus/ PoE Power Supply Type End-span + mid-span Power Pin Assignment 1/2(+), 4/5(+), 3/6(-), 7/8(-) Per Port 51V DC, 300mA. max. 15.4 watts (IEEE 802.3af) PoE Power Output Per Port 51V DC, 600mA.