Operation
Please note that the resource allocation will not change immediately when
a new mode is selected. It changes only after the next Power Up or System
Restart. See Restart the Switch.
The following table shows the resource distribution between modes.
MODE
Standard
Client Server
Peer to Peer
Selecting a Buffer Mode
Standard Mode shown in Fig. 3.9 illustrates memory allocation distributed
evenly across all ports.
FSD-1020 User's Manual
Using Condition
The load for every 10Mbps port is
evenly distributed.
It is suitable for the network
running in client server mode. The
server is better to be connected in
port 1~4. The budget for port 1~2
is smaller than port 3~4 whereas it
is larger than port 5~10.
Meanwhile, the budget for port
3~4 is greater than port 5~10's
budget. If hubs are connected, it
is preferred to connect them to
ports 1~4.
Resource for port 3~6 are larger
than ports 7~10.
Table 3.6 Resource Mode.
3-17