Intake Muffler Installation - FULTON PulseHW Series Installation, Operation And Maintenance Manual

Assembly should be completed within 20 seconds after last application of cement.
Do not use hammer to insert pipe.
Figure 7

18. Intake Muffler Installation

a) Follow steps 1-9 above for cementing joints. For best noise attenuation, the muffler
should be installed as close to the boiler as possible.
Fulton Heating Solutions, Inc. -- PHW Manual -- 2010-0713
Note
8. After assembly, wipe excess cement from pipe at end of fitting socket. A
properly made joint will show a bead around its entire perimeter. Any
gaps may indicate a defective assembly due to insufficient cement.
9. Handle joints carefully until completely set.
Page 38