Securing The Awning To The Rail; Installing The End Covers; Post-Installation; Disposal - Dometic 9200 Series Installation Instructions Manual

Post-Installation

7 .7 Securing the Awning to the Rail

This section describes how to attach the awning fabric to
the awning rail.
26 Securing the Awning Fabric
#6-20 x 7/16 in. Self-drilling
q
Hex Head Washer Screw
Awning Rail
w
1. Remove slack by pulling the right edge of the awning
fabric approximately 1/4 in. (6.3 mm) to the right.
2. Secure the fabric with one #6-20 x 7/16 in. hex head
washer screw through the awning rail, approximately
2 in. (50.8 mm) from the fabric edge.
The screw secures the awning fabric to the awning
I
rail and prevents side-to-side fabric movement.
3. Repeat Steps 1–2 on the LH side, pulling the fabric to
the left.

7 .8 Installing the End Covers

(LH)
27 Installing the Covers
Snap the hardware end covers into place.
16
q
w
2"
e
Awning Fabric
e
Edge
(RH)
8 Post-Installation
Complete the following steps to verify a proper
installation.
1. With power applied to the awning, open and close
the awning to verify that each part functions correctly.
2. Verify the alignment and that the hardware nests
properly. Adjust the hardware if necessary.
I See instructions included with your RGB LED
Controller & RF Wireless Remote 3317228.000 for
additional LED Remote testing instructions.

9 Disposal

Place the packaging material in the appropriate
M
recycling waste bins, whenever possible. Consult
a local recycling center or specialist dealer for
details about how to dispose of the product in
accordance with all applicable national and local
regulations.
LIMITED ONE-YEAR
WARRANTY
LIMITED ONE-YEAR WARRANTY AVAILABLE AT
WWW.DOMETIC.COM/WARRANTY.
IF YOU HAVE QUESTIONS, OR TO OBTAIN A COPY
OF THE LIMITED WARRANTY FREE OF CHARGE,
CONTACT:
DOMETIC CORPORATION
CUSTOMER SUPPORT CENTER
1120 NORTH MAIN STREET
ELKHART, INDIANA, USA 46514
1-800-544-4881 OPT 1
9200 Series Power Awning
EN