9200 Series Power Awning
Top Wiring Harness Notch
y
u
e
w
o
q
a
1 Hardware Dimensions (back channel)
I
Wiring harness location may be at the top or
bottom, depending on the awning model.
8962XX1 .4X0#(L)
62-3/4 in. (159.4 cm)
q
62 1/8 in. (157.8 cm)
w
60 1/8 in. (152.7 cm)
e
8962XX2 .4X0#(L)
66-1/4 in. (168.3 cm)
q
65-5/8 in. (166.68 cm)
w
63-5/8 in. (161.6 cm)
e
64-1/4 in. (163.2 cm)
r
65 in. (165.1 cm)
t
33 in. (83.8 cm)
y
8962XX3 .4X0#(L)
66-1/4 in. (168.3 cm)
q
65-5/8 in. (166.7 cm)
w
63-5/8 in. (161.6 cm)
e
EN
i
d
s
t
r
Bottom Wiring Harness Notch
60-3/4 in. (154.3 cm)
r
61 1/2 in. (156.2 cm)
t
39 in. (99.1 cm)
u
3/8 in. (1.0 cm)
i
1/4 in. (0.6 cm)
o
5/8 in. (1.6 cm)
a
3/4 in. (1.9 cm)
s
1-1/2 in. (3.8 cm)
d
64-1/4 in. (163.2 cm)
r
65 in. (165.1 cm)
t
5 Pre-Installation
This section provides instructions to complete before the
installation.
5 .1 Preparing the Awning Rail
NOTICE: Ensure the awning rail is parallel to the RV
floor, and is not warped or curved, before installing
the awning fabric. If the awning rail is not straight, the
awning fabric may wrinkle or stretch.
2 Flaring the Rail End
LED Awning
q
(Top Only)
Complete the following steps to prepare the awning rail.
1. Select a rail end (on the RV) to insert the awning
fabric.
2. Flare (widen) this rail end with a flat-bladed
screwdriver, and remove (file) burrs or sharp edges.
If the awning is equipped with an LED lighting strip,
I
flare only the top of the awning rail end. The LED
rail attached to the fabric will slide into the flared
awning rail. If the awning is not equipped with an
LED lighting strip, flare the top and bottom of the
awning rail end.
5 .2 Preparing the Awning Assembly
I
The motor is already installed on the right hand (RH)
arm assembly. The motor and the Slic pin cannot be
removed once they are installed.
Pre-Installation
q
w
Typical Awning
w
(Top and Bottom)
5