Dometic 9200 Series Installation Instructions Manual page 13

9200 Series Power Awning
20 Installing the Wiring into the RV
Grommet
q
Wiring
w
Complete the following steps to connect the power
awning motor wiring.
1. Plug the motor wire into the motor wire harness at the
top of the front arm.
2. Pull the motor wiring through the wiring hole and
grommet, and connect to the appropriate wiring inside
the RV.
3. Make the electrical connections inside the RV.
4. Secure any slack motor/hardware wiring inside the
front channel to prevent pinched or damaged wiring
during awning operation.
I See the instructions included with your Dometic
Corporation switch kit for additional wiring
instructions.
EN
e
q
w
RV Wall
e
7 .4 .2 White or Blue LED Light
Connections
Complete this procedure only if the awning is
I
equipped with a white or blue LED light strip.
21 Making the LED Blue or White Light Connections
LED Light Strip Wiring
q
1. Connect the LED switch wiring to the factory-wired
LED light strip.
2. Secure the wiring to prevent pinching or other
damage during awning operation. Allow enough
slack in the wiring to safely accommodate possible
fabric movement.
See instructions included with your LED switch kit
I
(installer supplied) for additional wiring instructions.
Installing the Awning
q
w
LED Switch Wiring
w
13