Installing The Electrical Wiring - Dometic 9200 Series Installation Instructions Manual

9200 Series Power Awning
5 .3 .1 Door Clearance
This section provides clearance measurements for the
awning's placement.
When the entry door is toward the center of the
I
awning, add 2 in. (5.08 cm) to minimum distances.
w
6 Door Clearance Distance
Awning Rail
q
Model
8962XX1.4X0#(L)
8962XX2.4X0#(L)
8962XX3.4X0#(L)
I Doors, windows, lights, trim, and slideout rooms
must be considered when determining the length
and position of the awning to ensure that the awning
will not obstruct them or be affected by them.
5 .3 .2 Installing an Optional Roller and
Edge Guard
NOTICE: Do not allow the corner of the entry door to
contact the awning fabric, or premature wear or tearing
of the awning fabric could occur. If there is potential for a
squared corner entry door to contact the awning fabric,
a door roller kit (not included) must be installed.
This section provides instructions for the optional door
roller kit to protect the awning.
EN
q
X
Entry Door
w
Min . Distance (X)
12 in. (30.5 cm)
7 in. (17.8 cm)
6 in. (15.2 cm)
q
7 Roller Clearance
1/4–3/8 in. (0.6–1.0 cm)
q
Above Door
q
w
8 Door Edge Guard
Door Edge Guard
q
6 Installing the Electrical
Wiring

WARNING: ELECTRICAL SHOCK HAZARD .
Failure to obey the following warnings could
result in death or serious injury:
• Disconnect all electrical connections from the RV for
all procedures under this section.
• The awning must be on a 12 VDC 15 Amp protected,
dedicated circuit.
This section provides instructions for wiring installation.

Installing the Electrical Wiring

w
Outer Entry Door
w
Inner Screen Door
w
7