Advantech MIC-3385 Manual page 29

To install a card:
1. Hold the card vertically. Be sure that the card is pointing in the
correct direction. The components of the card should be
pointing to the right-hand side.
2. Pull out both handles to unlock it.
Caution: Keep your fingers away from the hinge to prevent
your fingers from getting pinched.
3. Insert the card into the chassis by sliding the upper and lower
edges of the card into the card guides.
4. Push the card into the slot gently by sliding the card along the
card guide until the handles meet the rectangular holes of the
cross rails.
Note: If the card is correctly positioned and has been
slid all the way into the chassis, the handle
should match the rectangular holes. If not,
remove the card from the card guide and repeat
step 3 again. Do not try to install a card by
forcing it into the chassis.
5. Pull the upper handle down and lift the lower handle up to push
the card into place.
6. Secure the card by pushing in the red handle to lock it into
place.
To remove a card:
1. Unscrew the screws on the front panel.
2. Lift the upper handle up and press the lower handle down to
release the card from the backplane.
3. Slide the card out.
Chapter 2 Connecting Peripherals21