Table of Contents
Advertisement
Figure 6 Power module removal procedure
Before you remove a power module, prepare an ESD wrist strap
yourself.
Removing the power cord
1.
Turn off the circuit breaker of the power cord.
2.
Wear an ESD wrist strap, and make sure the strap makes good
skin contact and is correctly grounded.
3.
Remove the cable tie, and pull the connector out.
Removing the power module
CAUTION:
Before you insert a removed power module into a power module
slot, make sure the LEDs on the power module are off.
11
Advertisement
Table of Contents
Need help?
Do you have a question about the SecPath PSR3000-54A and is the answer not in the manual?
Questions and answers