Configuration Of Cooling Outputs; Configuration Of Continuous Outputs On "Cc" Module - gefran GEFLEX Multifunction Operating Instructions And Warnings

3.6 Configuration of continuous outputs on "CC" module

OUT for load 1
(OUT 1 from software)
OUT for load 2
(OUT 7 from software)
3.5 Configuration of cooling output
If you use the continuous cooling output (order code "C"), you
can use a selector to change the factory setting from voltage
(0/2...10V) to current (0/4...20mA).
If you use the module with double continuous output (order
code "CC"), you can use two jumpers on the module to
change the factory setting from voltage (0/2...10V) with
jumpers, to current (0/4...20mA) without jumpers.
31
Use a screwdriver to access the
selector through the slot.