Loading Film - Royal Sovereign RSL-2700 Owner's Manual

LOADING FILM

< Thermal Film Loading & Threading >
Loading Film
1. Remove the upper and lower film shafts from the
machine and load the films (do not tighten the core
screws at this time)
2. To load the top film, insert 1" core as shown on
Figure 1 (Note the direction that the film is wound)
3. Insert the shaft as shown in Figure 2.
4. Insert the core plug on the left hand side. (Figure 3)
5. Align and center the film and tighten the two core
screws. (Figure 4)
6. Repeat steps 2 through 4 to load the lower film.
(Please note the direction that the film is wound
for the bottom roll). (Figure 5)
7. Load the upper and lower film shafts on the machine.
* When loading 27" film on the lower, be sure to insert
the film core deeply into the film roll core to provide
room at each end.
7
RSL-2700
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5