Charge The Batteries - Walkera ZHUN Quick Start Manual

ZHUN
Quick Start Guide

6.0 Charge the Batteries

6.1 Remote control charging
Tip: The device is equipped with a build-in lithium battery
of 7.4V9000mAh,please use DC 15V4A for charging.
1) Connect the charger to the AC power (100 ~ 240v 50/60Hz).
2) Please turn off the remote controller before charging.
3) The charging completion indicator of remote controller turns green means remote controller charging finished
completely.
6.2 Aircraft battery charging
Steps
1) Power on: Connect the AC power, turn on the power switch, the charger will "click", the fan will rotate once, and
the LCD will display the following interface.
Battery Type(LiPo/LiHV)
Charging current (1.0-20.0 A)
2) Connect the battery: Please connect the battery and charger according to the Schematic diagram below.
(Note: The number of lithium battery packs that support charging is 12 knots; the battery charging cable and
the balance port must be connected to the charger at the same time.)
Connect the balance charging cable as shown in red arrow.
Connect the battery charging cable as shown by the blue arrow (Choose any red and black cable).
3) Start charging: Press both
the screen, Press the button
/
STOP
Fig.6.2-3
10
FAST CHARGE
LiPo
20.0A Off-line
Fig.6.2-1
and at the same time and last for 5 seconds until the battery type is LiHv on
for 2 seconds and then press the button
/
STATUS START
Working modes (fast charge,balance charge & storage)
Synchronous status(Off-line, Master, Slave)
Fig.6.2-2
LiPo
FAST CHARGE
Off-line
20 .0 A
Walkera All Rights Reserved
Charging port
Fig.6.1
to confirm charging.
LiHV FAST CHARGE
Off-line
20 .0 A
Fig.6.2-4