Remote Control - ADJ LTS COLOR User Manual

R E M O T E C O N T R O L
PAIRING: The original remote that comes in the box is already paired to the unit. In the event that
the remote is not paired with the unit, or if pairing to an additional unit, follow the steps below:
1) Unplug the power to the main unit and reconnect the power after ten seconds.
2) Press the "SPEED –" and "SPEED +" keys together within 5 seconds of reconnecting the
power.
CHANGE OUTPUT COLOR SEQUENCE: The default output color sequence is: Green, Red, and
Blue. If for any reason, the unit is displaying a different sequence, or the Direct Color Select keys
do not match, the unit can be reconfigured by following the steps below:
1) Unplug the power to the main unit and reconnect the power after ten seconds.
2) Press the "RED" and "Blue" keys together within 5 seconds of powering the unit on.
a. The unit will toggle between 6 color combinations and the sequence will be memorized.
POWER
Turns the unit ON and restores the unit to previous status. If the unit is on, the unit will enter standby
mode.
DEMO
Play 17 dynamic modes in a loop. Each mode repeats 3 times.
MODE +/-
This button lets you cycle through color fade mode, color
change mode, and auto run modes. Each press of the button
will change to the next mode. There are 22 different programs.
You can use the "+" and "-" buttons to cycle through the 22
programs.
SPEED +/-
There are 10 speeds to choose from. Select the speed using
the "SPEED +" or "SPEED –" button.
COLOR +\-
There are 20 colors to choose from. Select the color using the
"COLOR +" or "COLOR –" button.
BRIGHT +\-
There are 8 brightness levels to choose from. Adjust the
brightness using the "BRIGHT +" or "BRIGHT –" button.
DIRECT COLOR SELECT BUTTONS
There are 7 shortcut keys. Each key represents a static color.
These colors are also included in COLOR +/- selections.
15