Auto Reset; Hold Time; Display; Torque Crs - norbar NORTRONIC 43501 Operator's Manual

Auto Reset (Hold Time ?)

Auto Reset ?

Not Enabled
 Enabled = Hold the torque (and angle) values the length of the
been removed and then reset the display to 0.
 Not Enabled = Hold
reset the display to

Hold Time ?

Hold Time ?
4
Sec
 Minimum = 1, Maximum = 10. Default =

Display

Inverse ?
Not Enabled
Black
 Enabled = digits on
in the Measure display.
WARNING:

Torque CRS

Distance ?
31.8
 Minimum = 0.0, Maximum = 999.0. Default: - NorTronic
Press
If Enabled, pressing
Hold Time
If Not enabled the user will return to SETUP.
the torque (and angle) values until the ZERO button has been
0.
Press
Press
4
Press
Press
White
background, Not Enabled =
WHITE DIGITS ON BLACK BACKGROUND WILL REDUCE THE
OPERATIONAL BATTERY LIFE BY APPROXIMATELY 65%.
Press
Press
mm
or to change setting.
or
?'.
Hold Time
or to change value.
or to confirm and go to
or to change value.
or to confirm and go to
White
digits on
or to change value.
or to confirm and go to
®
50 & 200 = 31.8
will take the user to 'SETUP
setting after the torque has
pressed and then
SETUP (saving changes).
SETUP (saving changes).
Black
background, when
SETUP
(saving changes).
®
mm, NorTronic 330 = 35.0 mm.
21