Advertisement
Press the program button and "CS-5, SET, YEAR" shows in the display with the
8 8 ) )
year flashing. Press the up or down button to change the year.
Press and hold the program button to exit programming.
9 9 ) )
4 4 . . 4 4 S S p p e e c c i i a a l l P P r r o o g g r r a a m m M M o o d d e e
This section shows how to access the Special Program area of the controls in order to
program cook menus, clock, and other features. Perform the following procedure
before each step of the Special Program Mode.
Press and hold the program button until the display reads "LEVEL 2", "CLOCK
1 1 ) )
SET".
Press the program button again then "SP PROG" shows in the display.
2 2 ) )
After 5 seconds, "ENTER CODE" shows in the display.
3 3 ) )
Using the hidden buttons, enter code 1, 2, 3. See
4 4 ) )
Button Location , page
NOTE: A total of 5 hidden buttons exit. If the wrong code is entered, "INVALID CODE"
scrolls across the display, and the controls automatically exits the Program Mode.
See
Table 4-1 Special Program Modes , page 20
seeTable 4-2 Special Programming Procedures , page 21
for Special Program Modes.
Program
Code
SP-1
SP-2
SP-3
SP-4
SP-5
SP-6
SP-7
SP-8
SP-9
SP-10
SP-11
SP-12
SP-13
20
19.
T T a a b b l l e e 4 4 - - 1 1 S S p p e e c c i i a a l l P P r r o o g g r r a a m m M M o o d d e e s s
Degrees Fahrenheit/Celsius
Lock/Unlock
Air Temperature Setpoint
Humidity Setpoint
Out of Water Trip Point
Clean Water Pan Setpoint
System Initialization (Factory Settings)
Audio Volume
Audio Tone
Audio Effects
Language Options
CE Heat Regulation
Water Fill Option
Figure 4-1 Hidden Number
for program code descriptions;
for navigation instructions
Description
Advertisement
