C C h h a a p p t t e e r r 3 3 O O p p e e r r a a t t i i o o n n
3 3 . . 1 1 I I n n t t r r o o d d u u c c t t i i o o n n
This section provides operating procedures for the humidified holding cabinet. Read
Chapter 1 Introduction , page
Operation , page 11
before operating the unit.
3 3 . . 2 2 O O p p e e r r a a t t i i n n g g C C o o n n t t r r o o l l s s & & I I n n d d i i c c a a t t o o r r s s
The operating controls and indicators are shown in
Indicators , page
11, and described in
11.
Figure 3-1 Operating Controls & Indicators
T T a a b b l l e e 3 3 - - 1 1 O O p p e e r r a a t t i i n n g g C C o o n n t t r r o o l l s s & & I I n n d d i i c c a a t t o o r r s s
Item
Description
No.
1
Power Switch
2
Temperature LED
3
Temperature Button
4
Digital Display
5
Humidity LED
Chapter 2 Installation , page
1,
Figure 3-1 Operating Controls &
Table 3-1 Operating Controls & Indicators , page
A rocker switch that sends electrical current to the operat-
ing components and lights when turned on.
Lights when the control calls for heat, and the unit should
start heating. It goes out once the temperature inside the
cabinet reaches the programmed temperature setting.
Press the temperature button to set the cabinet
temperature.
Shows the cabinet temperature, humidity settings, and the
selections in the Program Mode. The temperature of the
cabinet is shown by pressing the info button. If the temper-
ature exceeds 300°F (149°C), the display reads "E-5",
"TOO HOT".
Lights when the control calls for humidity. It goes out once
the humidity inside the cabinet reaches the programmed
humidity setting.
3, and
Chapter 3
Function
11