Programming Of Functioncodes - Hengstler tico 732 User Manual

5.2 Programming of functionscodes
Programming mode:
press while
switching
Power on
function
basic settings
Shift-
counter
mode
resolution
signal time
output 1
signal time
output 2
pnp/npn-
selection
input
attentuation
dyn./static
Reset
Without/with
preset values
keylock for
reset key 6+4
keylock
for preset 1
keylock
for preset 2
keylock for prescaler
keylock mode for
(F20-F23)
* default values
2
parameter only appears for 2 preset version and F 16 = 1
Sach-Nr. 2 732 017; Version 1310301WBI
Change parameter:
press
code alternatives/signification
F0 0* no function
1 all function codes are set to the *-marked values
F1 Input A
0* adding
1 adding
F3 0* no decimal point
1 one decimal place (xxxxx.x)
2 two decimal places (xxxx.xx)
3 three decimal places (xxx.xxx)
F6 2 OFF no Output signal
On bistable Output signal (latching), will be deleted by Out 2
0,02 20 ms
0,05 50 ms
0,10* 100 ms
0,20 200 ms
0,50 500 ms
1,00 1 s
2
F7 see see above; signal time output 1
above
F10 0 npn with 8V level (negative)
1* pnp with 8V level (positive)
2 npn with TTL-level
3 pnp with TTL-level
F11 0 30 Hz attenuation (for contacts)
1* no attentuation, 5 kHz
(bidirectional counting: 2,5 kHz)
F12 0* static reset
1 dynamic reset (counting possible during reseting)
F16 0* without preset values
1 with preset values (only by counter with 2 preset values)
F20 0* key reset is possible
1 key reset is not possible (or possible with delay
see F29)
F21 2 0* access to preset 1 is possible
1 access to preset 1 is not possible (or delayed see F29)
2
F22 0* access to preset 2 is possible
1 access to preset 2 is not possible (or delayed see F29)
F23 0* access to prescaler is possible
1 access to prescaler is not possible (or delayed see F29)
F29 0* access to parameters from F20-F23 is possible after
holding the keys for more than 10 sec.
1 access to parameter is not possible
Change to the next function:
press
Input B
adding
subtracting
Return to count mode:
press > 5 s e c
Input C
reset
reset
17/28