Table of Contents
Advertisement
Lift1 Programming
Before you start
·
Make sure that your phone supports tone dialing.
·
Complete all the values to be modified into a pre-prepared form, which provides a clear table
of basic functions.
·
If your Lift1 is not brand new, make sure that you have the correct service password and, if
you are not completely sure of your Lift1 configuration, execute full initialization (Warning:
The service password will also be initialized!).
Access to Programming Mode
You can only enter the programming mode during an incoming call (from a phone to Lift1). Enter
the access password:
service password
If the password is correct and programming is enabled (jumper), Lift1 announces:
„You have entered the programming mode"
and displays a Help according to the context. The default password is 12345 and you are
recommended to enter a different password to protect your device against unauthorised persons.
Tips
·
If you forget your service password, use the programming tool and PC with 2N® Service
Tool.
·
While entering the password, keep a timeout of 5 seconds (or any other value in the range
between 1 and 9) for each character to avoid Lift1 hang-up and password/parameter re-
entering.
Programming Procedure
Having entered the programming mode, you can change any programmable value(s) in any order.
Proceed as follows: enter the parameter number and value. Use an asterisk as a separator or
Enter. In general, the function has the following format:
Parameter number
The parameter number has three digits (see the table). After you enter the number and an
asterisk, Lift1 shall report the number/name, current value and potential range of the parameter
to be programmed. After you enter the value and another asterisk, Lift1 shall announce "New
value stored", or "Invalid value" if the value is beyond the allowed range.
Programming Error
·
If you make a mistake while entering a number (function or value) and find it before
clicking the asterisk, press
·
If Lift1 rejects a parameter number or value, you can go on programming – enter the
function number although you typed a wrong value.
·
If you have programmed and saved a wrong value, re-enter a correct value.
Programming End
·
Having saved all the values to be modified, press
and hang up.
·
If you do not press
(the values are stored immediately in the memory).
(remember to enter an asterisk in front of and behind the password!)
value
to cancel the whole number and enter a new one.
, Lift1 will hang up later without affecting the value saving process
to make Lift1 send an on-hook signal
EN
Advertisement
Table of Contents
