Table of Contents
Advertisement
Sortiment
Part No.
919640xx
919618xx
Extending modules
Part No.
913648E
919649E
919650E
919621E
919680E
Description
®
2N
Lift1 (hereinafter referred to as Lift1) is designed for calling to predefined phone numbers. It
is usually used for emergency call from lift to the control centre or to the person who takes care
of the lift. A PSTN or alternative (PBX, GSM gateway) line is used for connection with the control
centre.
The basic version is dedicated for mounting behind the lift panel, there must be welded screws or
holes for mounting. The speaker, microphone and indicating LEDs can be mounted to the front
panel of the device or can be delivered separately with cables to be mounted anywhere on the lift
panel according the design (cable version). Model with the cover panel includes the front, visible
cover, this cover overlaps borders of the mounting hole. It doesn't need exact mounting holes and
the design of the space for speaker and microphone is solved.
For mounting on the top of the cabin surface is designated the 2N
robust metal cover, which includes all parts needed for function including the alarm button. The
description is not part of this manual, for information contact the producer.
Operation
Press the ALARM button to activate connection. The "Wait" pictogram goes on immediately and
the "Connection established" symbol goes out when communication has been set up. You can use
automatic dialing of up to six pre-programmed numbers. Communication is accompanied by
factory announcements and/or user recorded lift ID messages.
Service and Operating Staff Instructions
In the Automatic Dialing with Confirmation mode – default settings:
DTMF charter:
Function
Confirm to Lift1 that the call was successful. Lift1 shows the
connection by appropriate pictogram, mutes the currently played
announcement and allows the call till time limit is exhausted.
Mute the actual automatic announcement.
Description
Basic model for mounting below the panel
Model with the front panel
Description
Universal switch – remotely controlled switch by
DTMF, one switch or lift blocking module can be used.
Lift blocking module – blocks the lift function during
telephone line failures.
Amplifier module – for increasing volume in noisy
environment
Induction loop – for persons with hearing aid,
includes a self-adhesive holder and 1 m cable.
Programming tool – interconnects Lift1 with the
®
2N
Service Tool on the PC for programming.
®
Lift1 Compact version, in
EN
Advertisement
Table of Contents
