Table of Contents
Advertisement
Connectors for external LED supplied from Lift1 and connectors for external microphone and
speaker can be used for connecting of these parts on cables, allowing the user to place it
according the construction of the lift cabin. These parts are delivered with the cable version of
Lift1. These parts must be isolated for minimum breakdown voltage 1500 V (see the safety
caution). Induction loop is the Accessory equipment for persons with hearing aid, it can be used
only in very short distance from the loop. When the whole lift cabin should be covered with signal,
amplifier for induction loop must be used, for more information contact producer.
There is possible to equip Lift1 with universal switch remotely DTMF-controlled or by Lift blocking
module to block the lift function during telephone line failure. The Amplifier module is accessory
equipment for increasing volume in noisy environment, it needs external supplying and it is
electrically separated from the power line.
Wiring diagram for externally
supplied indicators
Note
·
Use 12–24 V DC of any polarity for voltage control. However, make sure that the source is
backed up against power outage. You can also connect a buzzer or horn in parallel with the
ALARM terminal if voltage control is used.
·
You can also use the NO contact or voltage presence for Alarm1 and Cancel activation and
invert the function using parameters 920 or 916 if necessary – NC contact or voltage
absence for activation. The logic of the Alarm1 functionality can be set automatically when
the device is first time switched on, the input has to be in not active alarm state.
·
Make sure that the DoorOpen signal is only activated when both the internal and
external lift doors are open and the people can leave the cabin safely.
Telephone Line Connection
Lift1 works regardless of polarity and/or line parameters in a wide range (see the Technical
Parameters section). It is connected via the LINE terminals. A great advantage is that Lift1
requires no additional power supply for operation. For details on Lift1 connection to PSTN, PBX
and GSM gateway lines refer to the Lift1 Connecting Options section.
Don't use LED holders, which are
not isolated for 1500 V for LEDs
supplied from Lift1!
EN
Advertisement
Table of Contents
