ADA INSTRUMENTS ROTARY 400 HV Servo Operating Manual page 9

ROTARY 400 HV
Servo
INSTRUMENTS
5. To make the beam more visible, change the rotating speed using the speed key, or use the Laser Detector to detect the laser
beam.
6. Press the Auto-Drift key to automatically stop the laser beams while the unit is self-leveling.
7. You can use the remote control to control the instrument. This option is very useful for trench work or when laying
concrete.
8. To turn the instrument off, press the Power key.
Vertical Plane (Automatic Mode)
The instrument can be used for creation of vertical line.
1. Position the instrument on its side on the ground, on any stable surface or on a standard 5/8" tripod. Set up the
instrument approximately level by adjusting the legs or the tripod; the instrument can compensate for a variance of up
to ±5° from the vertical plane.
2. Press the Power key. The Power Indicator will light up. If the instrument is set up outside the ±5° limit the Manual
Indicator will blink, the laser beams with not be projected and rotation will not begin. Please turn off the instrument and
set up again.
3. Verify that the instrument is in automatic mode – the Manual Indicator must be unlit.
4. The instrument is ready for work when the Power Indicator is lit, the Manual Indicator has stopped blinking, and the
laser beams are projected. The instrument is now leveled and the laser head will rotate clockwise at 600 rpm.
5. To make the beam more visible, change the rotating speed using the speed key, or use the Laser Detector to detect
the laser beam.
6. Press the Auto-Drift key to automatically stop the laser beams while the unit is self-leveling.
7. You can use the remote control to control the instrument. This option is very useful for trench work or when laying
concrete.
8. To turn the Rotary Laser off, press the Power key.
9. Press Power button to turn the instrument OFF.
9
MEASUREMENT FOUNDATION