ADA INSTRUMENTS ROTARY 400 HV Servo Operating Manual page 10

ROTARY 400 HV
Servo
INSTRUMENTS
Inclined Plane (Manual Mode)
The instrument can be used for creation of inclined plane. This is very helpful for laying inclined concrete surfaces, ensuring
run-off from pathways, and laying water and sewage lines. You can set the instrument at any angle more that ±5 degrees.
1. Set up the instrument approximately level.
2. Press the Power key. The power indicator will light up. Wait until the instrument is self-leveled and the laser starts to
rotate.
3. Press the Auto/Manual Key. When the Manual Indicator lights, the instrument is in manual mode.
4. Incline the instrument at required angle and fix the position of the instrument.
5. To make the beam more visible, change the rotating speed, change scanning mode, or use the Laser Detector to detect
the laser beam.
6. To return to Automatic mode, press the Auto/Manual key. The Manual Indicator will turn off.
7. To turn the instrument off, press the Power key.
Changing Rotation Speed
The laser beam is more visible when the rotating speed is slower. Change the speed of the rotating laser head by pressing the
Speed key. The default option is 600 rpm. Pressing the key moves a step forward in the speed cycle (600- 0-120-300-600 rpm).
Scan Function
The Scan function is used to limit the area covered by the laser beam, for safety reasons or to improve visibility and sen-
sitivity. A smaller scan segment will be more visible than a larger one. The default mode is 360° rotation, which provides
a horizontal or inclined beam throughout the work area or room. The Scan Key changes the mode from 360° rotation to
360°- 180°- 90°- 45°-10°- rotation.
1. Press the Scan Key to change the scan width.
2. The scan mark can be accurately positioned using the Clockwise and Counterclockwise Rotation keys on the remote
control.
10
MEASUREMENT FOUNDATION