Lectrosonics SMB Series Quick Start Manual page 8

Configuring for Remote Function
Some transmitter settings can be changed with the
LectroRM App (available from a third party from
IOS and Android). However, you must first config-
ure the SMB Series transmitter to accept remote
commands:
1) Press and hold the Down Arrow Button then
power on the transmitter by pressing the
Audio and Freq buttons simultaneously.
2)
The LCD will display the status, either "rc ON" or "rc OFF." To change the
setting, press the Up or Down arrow button.
3) Power Off the transmitter by pressing the Audio and Freq buttons simulta-
neously. The RC setting will persist when you Power Up the transmitter
again.
Note: SMB Series transmitters with firmware version 1.6 and later are
factory set to "rc ON" by default.
Configuring for Power Restore
Power Restore will return your transmitter to set-
tings that were in effect before it was powered
off. This eliminates the need to manually turn the
power back on after a battery has run down all the
way.
1)
Press and hold the Down Arrow Button then
power on the transmitter by pressing the
Audio and Freq buttons simultaneously.
2) The LCD will display the status, either "rc ON" or "rc OFF." Press "AU-
DIO" or "FREQ" key to scroll to the "PbAc 0" setting and use arrow keys
to turn to "PbAc 1" for on.
3) When power is restored the unit will turn on with previous settings.
8
Remote Function Screens
Power Restore Screens
LECTROSONICS, INC.