Saving And Recalling Memory 1; Saving And Recalling Memory 2; Saving And Recalling Memory 3 - Air Lift WirelessONE 25870 Installation Manual

WirelessONE

Saving and Recalling Memory 1:

Saving and Recalling Memory 2:

Saving and Recalling Memory 3:

MN-751
Recalling Memory
• Initial press of any button will wake up display and not perform any function.
• Upon wake up the LCD will display the Desired pressure.
• Press the M1 button to set the M1 pressure as the desired pressure.
• Upon the press of the M1 button the display will display "M1".
• Once the button is released the display will display the new desired pressure
and transmit the desired pressure to the receiver.
Saving to Memory
• With the desired pressure on the LCD Press and hold the memory button for 5
seconds to set the desired pressure to memory 1.
• While the M1 button is pressed the display will display "M1".
Once the desired pressure is saved to M1 the display will flash the backlight
•
three times.
Recalling Memory
• Initial press of any button will wake up display and not perform any function.
• Upon wake up the LCD will display the Desired pressure.
• Press the M2 button to set the M2 pressure as the desired pressure.
• Upon the press of the M2 button the display will display "M2".
• Once the button is released the display will display the new desired pressure
and transmit the desired pressure to the receiver.
Saving to Memory
• Press and hold the memory button for 5 seconds to set the desired pressure
to memory 2.
• While the M2 button is pressed the display will display "M2".
Once the desired pressure is saved to M2 the display will flash the backlight
•
three times.
Recalling Memory
• Initial press of any button will wake up display and not perform any function.
• Upon wake up the LCD will display the Desired pressure.
• Press the M1 & M2 buttons to set the M3 pressure as the desired pressure.
• Upon the press of the M1 & M2 buttons the display will display "M3".
• Once the buttons are released the display will display the new desired pressure
Saving to Memory
• Press and hold M1 & M2 buttons for 5 seconds to set the desired pressure to
memory 3.
• While the M1 & M2 buttons is pressed the display will display "M3".
• Once the desired pressure is saved to M3 the display will flash the backlight three times.
11