Protecting The Environment; Technical Data - Nakayama MB5000 Translation Of The Original Instructions

Petrol motor cultivator

Hide thumbs Also See for MB5000:

Owner's manual (18 pages)

Table Of Contents

Table of Contents

Available languages

Enlarged version

secure the stop using the split pin (4).

Figure F: Now attach the Bowden cable (a) to the

top hole in the lever (b).

Figure G: Now undo the hexagonal nut (c) from

the adjusting screw on the Bowden cable

and insert the adjusting screw on the

Bowden cable through the hole in the

grip (d). Now fasten the hexagonal nut

you removed earlier on to the screw. The

position of the adjusting screw is ideally

towards the rear or middle of the thread.

You can check that it is in the correct

position by testing whether the cultivator

blades turn correctly when the clutch

lever is pushed as far down as possible

whilst the engine is running. If this is not

the case, the adjusting screw must be

unscrewed further to increase the tensi-

on of the V-belt. Undo the screw until the

blades rotate correctly.

Figure H: Use the supplied cable ties to secure the

Bowden cable to the grip (e).

Starting

For logistic and safety reasons, the machine is

delivered with no fuel in the tank and without oil.

Use standard unleaded petrol and engine oil with

the speci cation 10W40.

Figure I: Unscrew the oil dipstick from the oil ller

neck (f) and insert approx. 600 ml of oil

(up to the "max" mark on the dipstick).

Figure J: Now ll the tank with unleaded petrol.

Figure K: Secure the depth stop (3) in the required

position using the split pin (4). Figure L:

Swing the transport wheel (g) upwards

until the springs engage.

Figure M: Move the petrol cock (h) into the "On"

position.

Figure N: Move the starting lever into position α

(see Figure Q).

Figure O: Start the engine using the starter cable

(i). First pull the cable until you feel a

slight resistance and then pull it sharply.

Repeat this process until the engine

starts.

Figure P: To start the cultivator blades, press

the clutch handle (j) down and hold

it there. When you release the handle

the cultivator blade drive will be shut

down. To operate the chopping knives,

push the release lever (k) upwards, then

press the clutch lever (j) down.

Figure Q: The height of the handle console can be

adjusted to suit the height of the opera-

tor. To do this simply turn the screws on

the console base (2) further in or out.

Figure R: Di erent positions of the starter lever:

- α: Start position

- β: High engine speed

- γ: Low engine speed

- δ: Stop

Servicing

Use only the accessories and spare parts recom-

mended by the manufacturer.

If the machine su ers a failure despite our

constant quality controls and your care, have it

repaired only by an authorised electrician.

Spark plugs that can be used in this product: