Assa Abloy Yale Secure Connect MZ-1 Manual page 25

Adding & using devices
Adding & Using Devices
Smoke Detector
1
Testing
3
Smoke Detector testing should be done on a regular monthly basis. Pressing the test button will make
the LED flash, the audible sounder chime and will send a test signal to the Smart Hub when the button is
released. If nothing happens after pressing the test button, it indicates the batteries will need changing (see
page 26).
Recalibration
The Smoke Detector might need recalibrating after time to ensure it is working at its optimum. This is done
by pressing and holding the test button until the LED flashes and beeps after 10 seconds. The Detector will
then start its self calibration routine.
1
1
Panic Button
Activate an Alarm
Press and hold the red button for at least 3 seconds to activate a panic alarm.
Silence an Alarm
2
Press and hold down the red button for 10 seconds.
1
Silencing the alarm with the Panic Button does not reset the system. If the alarm is armed prior to activation,
the system will re-arm after being silenced with the Panic Button.
Resetting the system after a Panic Alarm
The system will require a reset at the Smart Hub after being silenced with the Panic Button. To reset the
Smart Hub unplug the AC power (a) and turn the battery switch off for 10 seconds. Turn the battery switched
back on and plug in the AC power again.
4
(a)
a
Smoke Detection
When smoke is detected the device will activate for a minimum of 10 seconds with a two
tone alarm and flashing LED.
Note: The Yale smoke detector is to be used for alarm notification only,
it is not to be used as the primary smoke detector on the premises.
2
Pressing the test button when in an alarm condition will silence the alarm for 10 minutes. It
will automatically resume smoke detection again after this period.
3
a
b
.
•
b
10 secs
25
25