Default Settings - Assa Abloy Yale Secure Connect MZ-1 Manual

Default Settings

Default Settings
All devices (except PC and PVC)
are pre-set to "entry" mode.
When the system is first armed, users will have 30
seconds to exit the building. If the system is already
armed, triggering any sensors will cause an entry
countdown to begin.
PC/PVC's default setting is "Burglar only", i.e.
immediate triggering during full arm and sleep during
Part Arm. This is done to conserve battery life.
You can change the entry/exit delay timing and other
settings for both fully armed and part armed mode.
Go to the app menu, select Settings > Alarm Settings >
System Settings.
Supervision off as default (recommended).
Please note that having supervision enabled could reduce the battey life of your devices.
This feature should only be used by a professional installer to check for outage and malfunctions with
your devices. Incorrect usage would lead to a supervision failure message showing on the app.
With the exception of the PIR Image Camera, PIR Video Camera and Smoke Detector (these always
have supervision turned on), the other devices you will need to have supervision manually enabled on
the device if required.
Supervision can be enabled via Settings > Alarm Settings > System Settings > General Configuration.
Jamming and interference
detection (default on).
.
•
Burglar
Burglar
Home Omit
Home Omit
Home Access
Home access
Entry
Burglar
Home Omit
Disarmed Part-Armed
Burglar
Disarmed
Home Access
Burglar
Home Omit
Entry
Home Omit
Home Access
Home Access
Entry
Entry
Entry
If jamming and interference is of concern, please
enable via "Settings > Alarm Settings > System
Settings > General Configuration''
Disarmed Part-Armed
Key
Disarmed Part-Armed Armed
Armed
Sensor
Part-Armed Armed
Ignored
Instant Siren
Triggers
Countdown
21
21