Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Assa Abloy HKC SW-10270
Summary of Contents for Assa Abloy HKC SW-10270
- Page 1 SW-10270/SW-10120/SW-20140 User Manual (UK & Ireland) April 2024 HKCsecurity.com...
- Page 2 Installer Address Phone 24 Hours Email Alarm Centre Install Date Please refer to RKP inner flap label for more details of Quick Codes, Inhibits and Audio Memo- Pad operation WARNING While this system has been designed to the highest standards it does not offer guaranteed protection against burglary or fire.
-
Page 3: Accessing The User Menu
Accessing the User Menu *if enabled by the installer followed by the USER CODE to go to the first Menu Item: Press to arm the system with an Fullset ? Press exit timer Press to scroll to: NEXT to quickly arm the system Quick Arm ? Press (without exit timer) - Page 4 Accessing the Manager Menu *if enabled by the installer to enter the Manager Menu (if Manager Menu? Press permitted) Press to scroll to: NEXT Set Date & Time Press to change the system’s date & time Press to scroll to: NEXT to view up to 999 events logged in View Eng.
- Page 5 Operating your system without a User Menu. To perform a FULL SET With Exit Timer Press followed by User Code Or If allowed Press followed by User Code NEXT “System Arming” Buzzer sounds for length of exit time Keypad displays exit time remaining To perform a FULL SET Without Exit Timer Press followed by User Code...
-
Page 6: Unsetting Your System
Unsetting your system To unset the system or cancel an alarm followed by User Code Press “System Unset” Note: In the event of an alarm activation then the keypad will make an announcement. PLAY You can terminate this by pressing QUIT Using a Proximity Tag to Set and Unset your System Just bring the tag to the keypad as shown. - Page 7 Partially Arming Your System Zones inhibited in Part Set will remain inactive for the duration of system set. Part Set A This will inhibit the following zones: Press followed by User Code PQRS NEXT “System Arming” Part Set B This will inhibit the following zones: Press followed by User Code NEXT...
- Page 8 Customised system setting To inhibit specific zones within your system CAUTION: when you inhibit a zone it will remain inactive for the duration of the system set. This feature should be used with caution having first identifies the reason for the zone condition Example: to inhibit a single zone (e.g.
- Page 9 Resetting your system remotely (UK only) Your system may be programmed to trigger a remote reset after a confirmed alarm activation. In this case, you will not be allowed to arm your system until you have performed a remote reset with your Alarm Receiving Centre, or until you have contacted your engineer who can reset the system by enter- ing and exiting engineer mode.
-
Page 10: Accessing The Wi-Fi Menu
Accessing the Wi-Fi Menu to enter the Manager Menu (if Manager Menu? Press permitted) Press to scroll to: NEXT Set Date & Time? Press Press to scroll to: NEXT Wifi Settings? Press to scroll to: Press NEXT This will start a new Wi-Fi scan and Change AP? show list of available Wi-Fi Access Press... - Page 11 Using your RF-Keyfob You can operate your system using remotely using your RF-Keyfob. Always make sure you get a green Transmission OK light otherwise you will have to repeat your key press. Indicator Light: Green: Transmission OK Red: Transmission Not OK Orange: Out of Range Duress Button...
- Page 12 HKCsecurity.com...
Need help?
Do you have a question about the HKC SW-10270 and is the answer not in the manual?
Questions and answers