Install The Pxie Modules; Cable The Modules - Keysight M9383A Startup Manual

Install the PXIe Modules

Place the M9300A Reference in Slot 10 (the timing slot).
Place the other modules in the slots on either side of slot 10 as shown in

Cable the Modules

Procedure for Installing Modules
Install the left-most module first and then continue installing modules from left to
right according to the following photo.
When installing each module:
Hold the module by the injector/ejector handle and make sure the injector
1.
/ejector handle is pushed down in the unlatched (downward) position, slide
the module into chassis using the slot guides (top and bottom).
Slide the module into position, when you begin to feel resistance, pull up on
2.
the injector/ejector handle to fully inject the module into the chassis
backplane connectors.
Tighten the module retaining screws (top and bottom) and torque them to
3.
5 in-lb (0.57 N-m).
Cable the Modules
Before you connect the cables to configure the system, refer to
for the front panel descriptions of the modules.
The images below show the recommended cabling configurations for M9383A VSG
in an M9018B/M9019A chassis.
Recommended Analog Configurations
41
.
Keysight recommends you to install all the modules in the exact order.
Generic module installation shown. It may not reflect your module's actual size
and chassis placement.
M9383A Data Sheet
Keysight M9383A PXIe Vector Signal Generator