Keysight M9383A Startup Manual page 38

Install a blank Y1213A filler panel in the empty slot to the left of the
2.
controller.
Connect the peripherals:
3.
Monitor with M9037A - Use the Display Port to VGA adaptor (an accessory
to the M9037A) if necessary
USB compatible keyboard
USB compatible mouse
Remote Controller
If your configuration contains a M9021A Cable Interface Module, follow the
procedure below. For additional information about installing the M9021A, refer to
the M9021A Installation Guide
Locate slot 1 in the chassis. It has the icon (
1.
Keysight M9383A PXIe Vector Signal Generator
Generic module installation shown. It may not reflect your module's actual size
and chassis placement.
While holding the module by the injector/ejector handle and making
a.
sure the injector/ejector handle is pushed down in the unlatched
(downward) position, slide the controller module into chassis, using
the slot guides (top and bottom).
Sliding the module into position, when you begin to feel resistance,
b.
pull up on the injector/ejector handle to fully inject the module into the
chassis backplane connectors.
Tighten the module retaining screws (top and bottom) and torque
c.
them to 5 in-lb (0.57 N-m).
.
) above it.
38