Prepare the PXIe Chassis
Make sure that the line cord is plugged into a grounded outlet to establish
1.
earth ground.
Make sure the chassis power switch is
2.
Position the chassis to provide ample space between the chassis fan intake
3.
and exhaust vents. Blockage by walls or obstructions affects the airflow
needed for cooling.
Before inserting a module into the chassis, back the mounting screws out to
4.
ensure that there is no interference between the screws and the mounting
rails.
Install the Controller
Use the instructions below for installing the
M9037A) or the
M9048A adapter for desktop PC).
Keysight M9383A PXIe Vector Signal Generator
remote controller
(Keysight M9021A Cable Interface with the
Do not power up the controller until instructed to do so later in this document.
Off
.
embedded controller
(Keysight model
36