Items You Will Need - Keysight M9383A Startup Manual

Items You Will Need

To complete the startup process and begin using the instrument, you will need the
following items:
Pozidriv P1 or slotted screwdriver to secure the modules into the chassis.
Adjustable torque wrench (at minimum, accommodate an 8 in-lb [0.904 Nm]
torque on SMA, 3.5 mm and 2.4 mm connectors).
A USB flash drive. Download the installer files to a computer, transfer the
installer files to a USB flash drive, and install the software from the USB
flash drive.
A high-quality SMA (male) to SMA (male) cable at least 10 inches (25.4 cm)
long. This cable is used in
signal analyzer other than the Keysight M9393A PXIe Vector Signal
Analyzer, the cable end at the signal generator RF Output may be different.
Keysight M9383A PXIe Vector Signal Generator
Step 6: Make a Measurement . If you are using a
10