Figure 8.3 Rear View Of Expansion Disk Cabinet - Fujitsu GP 7000F Manual

CHAPTER 8 Expansion Disk Cabinet
Rear Panel
Power Supply Unit
( Standard )
100
The Figure 8.3 shows the rear panel of Expansion Disk Cabinet.
SCSI OUT Connector
SCSI IN Connector( Option )
SCSI OUT Connector
SCSI IN Connector( Standard )
Service Pin
RCI Port
AC Power Input
AC Main Line Switch
Figure 8.3
The Expansion Disk Cabinet is not powerd on/off by only the main line switch, but it is linked to
power on/off of the GP7000F main cabinet. Note that this cabinet does not power on if the main line
switch is OFF, even if the GP7000F main cabinet is powered on. Keep the main line switch set to
ON for regular use.
Be sure to set the RCI configuration, which is detailed in Chapter13 , must be set properly when
installing an Expansion Disk Cabinet.
The cabinet has 2 pair of SCSI IN/OUT connectors on it. When the cabinet is configured without
expansion (optional) drive bays, a SCSI cable must be connected to the standard SCSI IN connector.
Be sure to install an UltraSCSI differential terminator plug on SCSI OUT connector.
Rear View of Expansion Disk Cabinet