Fujitsu GP 7000F Manual page 170

CHAPTER 11 Input-Output Units
Front Panel.
Tape cartridge information
136
The 8-mm tape unit has three LEDs and an eject switch as shown in Figure 11.10 .
2 Warning LED
1 Eject switch
Figure 11.10
1 Eject switch
This switch is used to rewind, unload, and eject the 8-mm data cartridge.
2 Warning LED
If this LED blinks, an error may be occurred in this unit. If Warning LED and Ready
LED blink together, this unit requires cleaning. And, it will light at reset or initial
power-on phase.
3 Ready LED
This LED lights, when 8-mm data cartridge is inserted and finished loading the tape.
And, it will light at reset or initial power-on phase, also.
4 Access LED
This LED lights steady or blinks, when the 8-mm drive is working (reading or writing
a tape). And, it will light at reset or initial power-on phase, also.
This tape drive unit uses EXATAPE 112m or EXATAPE 160mXL 8-mm tape cartridges, which
have typical storage capacity of 5 - 14 Gbytes.
Table 11.5
Tape Length
160 m
120 m
Note that the 8-mm tape unit can read tape written in EXB-8200 format, when the cartridge is set to
write-protected.
IMPORTANT
Never use 8-mm video media. Always use computer grade media.
4 Access LED
3 Ready LED
8-mm Tape Unit Front Panel
8-mm Tape Cartridge Capacity
EXB-8500 EXB-8500c
10 Gbytes 14 Gbytes
5 Gbytes 7 Gbytes