Fujitsu GP 7000F Manual page 184

CHAPTER 12 External Interfaces
Connection of signal lines
150
Figure 12.2 shows a configuration of signal line on connecting DCE device.
Controller/
adapter
(DTE)
Figure 12.2 Configuration of Signal Line when Connecting DCE Device(Example)
The configuration of the signal line on connecting DTE device is shown below.
Main cabinet side
Note:
RS/CS flow control cannot be achieved by
this wiring
Figure 12.3 Configuration of Signal Line when Connecting DTE Line(Example)
SD [Send Data]
RD [Receive Data]
RS [Request to Send]
CS [Clear to Send]
ER [Equipment Ready]
DR [Data set Ready]
CD [Carrier Detect]
ST1 [Send Timing 1]
ST2 [Send Timing 2]
RT [Receive Timing]
SG [Signal Ground]
I/O device side
SD SD
RD RD
ER ER
DR DR
RS RS
CS CS
CD CD
ST1 ST1
ST2 ST2
RT RT
SG SG
I/O Device
(DTE)