Fujitsu GP 7000F Manual page 197

Processor Monitoring Error Messages
In the power-on diagnostics, the processors, external caches, memory modules, etc. are diagnosed.
If a fault is detected in the processor during the power-on diagnostics and while the system is
running, the following error messages will be shown on the LCD panel.
Message level
(1st line)
SCF:alarm
Lithium Battery
An alarm message notifying the initialization of the calendar will be displayed, when cables to the
battery are temporarily disconnected to replace the lithium battery or when some other maintenance
work is performed. In such a situation, check the cables, then power-on the system with the MODE
switch is set to MANUAL. If the calendar is initialized due to some reason other than maintenance
work but remains some error after replacing the lithium battery, any other unit should be repaired.
Message level
(1st line)
SCF: warning
SCF: alarm
Table 14.5 Processor Monitoring Error Messages
Message content
(2nd line)
CPU Hangup nn Processor hang-up is detected in the power-up
processing phase nn.
CPU Hangup 00nn Processor hang-up is detected in the operating
system environment.
Table 14.6 Lithium Battery Error Messages
Message content
(2nd line)
Calendar Initial The calendar information has been cleared for a
moment due to battery replacement or discharge.
During power-up phase, the information may be
restored to reset the calendar automatically.
LiBATT Reduced lithium battery output voltage detected.
14.4 SCF Error Messages
Description
Description
163