Installation Design And Start-Up; Electrical Wiring Design Of The Installation - Ingeteam INGECON SUN STORAGE 1Play Installation And Configuration Manual

Installation and configuration of a stand-alone system

3 Installation design and start-up

This section describes the necessary steps to design and start up the installation. Proceed as
follows:

1. Electrical wiring design of the installation.

2. Electrical connection of the INGECON SUN STORAGE 1Play.
3. Configuration of the INGECON SUN STORAGE 1Play.
4. Updating firmware.
5. Monitoring of the installation (optional).
3.1 Electrical wiring design of the installation
The electrical circuit diagram of the self consumption installation managed by the ISS 1Play is
shown below.
For more information about this type of installation, see the "Technical guide for
installations with INGECON SUN STORAGE 1Play" available on the Ingeteam
website.
Installation components:
Photovoltaic panels.
Battery bank.
INGECON SUN STORAGE 1Play.
Support diesel genset (optional) that is connected in the case of an energy deficit.
Manual bypass switch (optional). In the event of an ISS 1Play fault or maintenance, this
allows for the loads to be powered from the grid. It is formed by 2 independent
interlocking manual switches that connect alternately.
Diesel support generator
Manual bypass
switch
Optional
Ingeteam