Titan SF2843 Safety And Operating Manual page 15

2. The saw blade moves slowly, Why?
If the battery is not fully charged, recharge the
battery with the supplied battery charger.
Note: Do not charge the battery with a different
charger. Charge battery pack only with the charger
provided.
3. I cannot fit the battery into the battery
charger. Why?
The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot, the red LED light
should turn on when the battery is charging. (See
fig2)
4. Reasons for different charging time.
Your charge time can be affected by many reasons
- which are not defects in your product. If the
battery pack is only partly discharged it may be
re-charged in less than 1 hour. If the battery pack
and ambient temperature are very cold then re-
charging may take 1 to 1 1/2 hours. If the battery
pack is very hot it will not re-charge because the
internal temperature safety cut-out will prevent it.
If hot you must remove your battery pack from the
charger and allow your battery pack to cool first
to ambient temperature and then recharging can
be started. If you charge a second battery pack
immediately after the first then the charger can
be over-heated. Always allow at least 15 minutes
rest between battery pack charging.
5. Reasons for different battery pack
working times.
Charging time problems, as above, and having
not used a battery pack for a prolonged time will
reduce the battery pack working time. This can
be corrected after several charge and discharge
cycles by charging & working with your saw.
Do not re-charge your battery pack below 2 C
O
(36 F) and above 35 C (95 F), as this will affect
O O O
performance.
18V JIG SAW SF2843
SF2843 CSJ18P-M-060419.indd 15 2006-5-25 16:38:19