Vaportek Valve Adapter Interface Kit - P/N 900Xxx-001; Vaportek Pump Characteristics - Veeder-Root VaporTEK Installation, Setup And Troubleshooting Manual

Introduction

VaporTEK Valve Adapter Interface Kit - P/N 900XXX-001

A B 0V 5Vout
X1
VTEK3-EPV-
ADAPTER
VEEDER-ROOT 141085646
F1 F3
SIDE A
Duncansville,PA.16
Type: EPV10
SIRA 12ATEX6058X -40°
Valve: II 1/2G c T3
Solenoid: II 2G Ex MB

VaporTEK Pump Characteristics

1. The VaporTEK Pump is driven by the VaporTEK Controller.
2. The VaporTEK Pump has integrated flame arrestors at the inlet and outlet ports that prevent flame
transmission.
3. The inlet/outlet ports have standard G ¼" female threads (ISO – 228-1).
WARNING! DO NOT remove the flame arrestors. DO NOT install piping which can stress the pump
housing.
4. Vapor flow is from the nozzle through the vapor pump to the UST (See Figure 3 for flow direction).
5. The following conditions must apply according to EN13463-1 for the maximum pipe and hose lengths
between the nozzle and the VaporTEK Pump.
a. An inner diameter
b. Coaxial hose of length

length 3m.
Quantity
X2
1 VaporTEK – Valve Adapter Board P/N –SK 141 085 646
SIDE B
4 Support Post, Dual Locking M4.0 X 6MM LG (Plastic), P/N 579081-001
1 Cable, 4 wire
2 EPV10
1 Cable 24VDC

10mm in the coaxial hose of length

6m with an outer diameter
Description

6m, OR

38mm together with a DN15 pipe (G ½"),
12
VaporTEK Pump Characteristics