HDL Buspro -MSM.431 User Manual page 37

User Manual
SB-DN-SEC250K
rd
b) Go to 'ENTER BUZZER ON', setup to trigger the Z-Audio(ID is 1/9) to play the 3 voice
when open the door.
4. The house owner go to the HDL-MPL8.48 to press the disarm button within 20s (Entry
Delay), then security module will work under the non-monitoring mode. Better to set
password for this arm/disarm page, then only the owner can access it to control.
5. If it's not the house owner, after 20s (Entry Delay), will turn to alarm. After 5 minutes of
alarm, still not disarm, stop alarm. When there are more triggers from 8in1 sensor, it will
start to alarm again, and that cycle repeats.
a) Set 20s for Entry Delay, 15s for Siren Delay, 5 minutes for Reset after Alarm.
b) Can set to trigger the alarm buzzer after 20s, e.g. the alarm buzzer is connected to
channel 1 of one relay(ID is 1/6), then can set as below:
c) It will trigger the alarm targets in the 'VACATION ALARM' after 20s at the same time.
Here set to open the curtain and turn on lights when alarm.
Advanced Security Controller – User Manual
34