Yamato IN604W Instruction Manual page 32

Input Program
Insert step into the position currently displayed
3
① Display the "Insert step" on the setting item selection screen and then press the ENTER key.
The screen returns to the setting item selection screen and the setting temperature of inserted
step is displayed.
 The "Insert step" is not displayed if no steps are left.
S01
 The initial settings below are set in the newly inserted step. The settings of "un-used" steps displayed
at the end of "Select step" are the same as that listed below.
Add step at the end of program
4
① Display the setting of un-used step on the setting item selection screen and then press the
ENTER key.
 The "SO1" (the first step) indicates "un-used" at the first registration of program.
 The items other than "Insert step", "Delete step" and "End program" can be set.
 The "un-used" steps are not displayed if no steps are left.
② Change the setting value and press the ENTER key.
③ The indication "un-used" on the lower column of Sub Display goes out.
Insert step
TROUBLE
ENTER CANCEL
(Decide the input)
Item
Setting temperature
Setting time
Repeat initiating step
Set TEMP
S23(un-used)
Set TEMP
S23
Set TEMP
S01
→
ENTER
(Selection screen)
Initial setting
0℃
0 minute
No
0.0℃
TROUBLE
ENTER
CANCEL
► 0.0℃
29
Operation Method
0.0℃
TROUBLE
CANCEL