Yamato IN604W Instruction Manual page 26

Program Operation
Set step number and start wait period/
3
time
① The initiating step input screen is displayed.
The Sub Display displays "First step" and the
step number blinks.
② Select the step number using the"▼▲" and then
check it using the ENTER key.
 The "steps that are not set" and "step within repeat"
are not displayed. If no program is registered (no
steps are used), the buzzer sounds with a message
on the Sub Display. In this case, register program
using the PROGRAM key and start the step again.
NO program
(Display in case no program
③ The operation start wait period/time input screen
is displayed after the step number is decided.
Display the operation start wait period/time using
the "▲▼".
Input the operation start wait period when the
setting of timer mode shows "Time". Input the
operation start time when it shows "Clock".
Wait ST 30min
Program OPR
(Operation start wait
period edition screen)
 Pressing the CANCEL key quit the setting of auto
start operation.
23
Operation Method
Registered
is registered)
Start Time
Program OPR
(Operation start time
edition screen)
13:00