Yamato IN604W Instruction Manual page 30

Input Program
2
① After the step number is decided, the setting item selection screen is displayed. Select the
items on the Sub Display using the PROGRAM key.
No. Item
Setting
1
temperature
2 Setting time
Repeat
3
initiating step
4 Repeat count
5 Step insertion
6 Step deletion
7 Program end
 The step number currently edited is displayed on the lower column of Sub Display. The details for all
registered steps in use are displayed followed by all un-used steps.
 The "Set TEMP" for the next step follows the "Program End". The screen, in this way, displays the
details of respective steps in sequence. The unused steps are displayed at the end if other steps are
used. The display "un-used" is added at the end of step number displayed in the lower column of
Sub Display for un-used steps. All steps subsequent to the step with "un-used" are un-used steps.
 The setting items are not displayed on the screen depending on the setting conditions shown
below.
Setting item
Setting temperature
Repeat initiating step
Repeat count
Step insertion
 It is impossible to change the content of program currently operated. Checking it is possible.
Sub Display
Set TEMP
37.0℃
S01
Set time 0min
S01
Rep. start S01
S01
Rep. count
S01
Insert step
S01
Delete step
S01
Program End
S01
Not displayed in the following condition
Not displayed when the setting time is set to "End".
Not displayed when the period is set to "End" or when the
other step is inserted in the specified repeat interval.
Not displayed when the repeat initiating step is not
displayed, or "No" is set.
Not displayed when steps are left.
27
Operation Method
5
Add a new step at the position of step
currently referred to. The sequence number
of each step hereafter increases by one.
Delete the step currently referred to.
sequence number of each step hereafter
decreases by one.
Complete program registration/edition.
Notes
The