Table of Contents
Advertisement
Chapter 3
Configuration
This section describes how to reconfigure options using the
Configuration mode, including output voltage and site wiring fault.
Configuration Mode
When the UPS is in Configuration mode, the bar graph indicators
represent the configuration options. The control buttons (On button
and
shows the LEDs and Table 4 explains the corresponding options.
NOTE
DO NOT press the Off
pressing the Off
and the UPS enters Standby mode.
Powerware
9125 Two-in-One (5000/6000 VA) PDM User's Guide
®
button) are used to modify the UPS configuration. Figure 19
The UPS can be configured while in Battery mode.
button while the UPS is in Configuration mode;
button removes all power to your equipment immediately
1.
Press the On button and the
three seconds. The UPS switches to Configuration mode.
The bar graph indicators flash briefly and then display the
enabled options.
2.
Press the On button to scroll through the options. Each time
you press the button, the UPS beeps. The LED for the selected
option indicates the current setting; flashing represents disabled
options (see Figure 19 and Table 4).
If you press the On button and nothing happens, the UPS is
still in Operation mode. Repeat Step 1 to enter Configuration
mode, and then perform Step 2.
C A U T I O N
button simultaneously for
Rev B www.powerware.com
S
31
Advertisement
Table of Contents
