Table of Contents
Advertisement
Installation
12.
13.
Failure to match the UPS voltage may result in a hazardous condition, including
damage to the UPS or to the load.
14.
15.
NOTE
power to all of the output receptacles on the PDM rear panel, but does
NOT shut off power to the UPS (opening the upstream protection would
be required).
16.
NOTE
However, it is recommended that the batteries charge for 24 hours after
installation or long-term storage.
20
Powerware
9125 Two-in-One (5000/6000 VA) PDM User's Guide
®
Press the On button on the UPS front panel.
µ
The
indicator stops flashing and the bar graph indicators
display the percentage of load being applied to the UPS.
Confirm the UPS output voltage through the front panel and
verify that it matches the PDM output voltage (see page 31).
C A U T I O N
Plug the equipment to be protected into the PDM output
receptacle(s).
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
Switch the PDM output circuit breaker to the ON ( | ) position.
The PDM output circuit breaker (disconnect switch) disconnects
Install the PDM front panel.
The batteries charge to 80% capacity in less than 2 hours.
Rev B www.powerware.com
S
Advertisement
Table of Contents
