Powerware PowerPass 9125 User Manual page 31

Table 2. Hardwired PDM Input/Output Voltage Settings
PPDM HW, and PPDM EURO HW Models
Input Voltage Input Voltage
(from UPS)
6.
7.
8.
Powerware 9125 Two-in-One (5000/6000 VA) PDM User's Guide
®
208V Switch Position
(HV/LV)
208 208/120
220 220/126
230 230/131
240 240/136
Remove the wiring access cover and the conduit landing plate
and retain (see Figure 11).
Punch holes in the conduit landing plate for the input and
output conduit using a Greenlee
Pull the input and output wires through separate conduit,
leaving approximately 2 ft (0.5m) of exposed wire. Attach a
flexible metal fitting to the end of each conduit.
Insert each conduit through a wiring access entry and attach the
conduit fitting to the panel. Strip 0.35I (9 mm) of insulation
from the end of each incoming wire.
S
PDM Output Voltage
Default 240V Switch Position
(HV/LV)
208/104
220/110
230/115
240/120
punch or similar device.
®
Rev B www.powerware.com
Installation
25