Table of Contents
Advertisement
Installation
4.
5.
NOTE
24
Powerware
9125 Two-in-One (5000/6000 VA) PDM User's Guide
®
Verify that the Bypass switch on the PDM is in the NORMAL
position (see Figure 10).
Bypass Switch
Figure 10. PDM (with Front Panel Removed)
Changing the PDM output voltage.
switch is set to the 240V position (the default), the output
voltage is 240V/120V. When set to the 208V position, the output
voltage is 208V/120V. See Table 2 for a list of PDM input/output
voltage settings. Figure 10 shows the voltage switch.
In most applications, the voltage switch does NOT need changing.
To change the switch position, remove the bracket screw and
turn the switch. Flip the bracket around to fit the new position
and reinstall.
Voltage Switch
When the PDM voltage
Rev B www.powerware.com
S
Advertisement
Table of Contents
