Transport Safety Information; Safety Information For Electrical Installation; Safety Information For Commissioning; Operating Safety Information - ABB TTH200 Commissioning Instruction

Safety
1.6

Transport safety information

Observe the following information:
• Do not expose the device to moisture during transport. Pack the device accordingly.
• Pack the device so that it is protected from vibration during transport, e.g. through air-
cushioned packaging.
1.7

Safety information for electrical installation

The electrical connections may only be performed by authorized specialist personnel according
to the electrical plans.
Comply with electrical connection information in the instruction. Otherwise, the electrical
protection class can be affected.
The secure separation of contact-dangerous electrical circuits is only ensured when the
connected devices fulfil the requirements of the DIN EN 61140 (VDE 0140 Part 1) (basic
requirements for secure separation).
For secure separation, run the supply lines separated from contact-dangerous electrical circuits
or additionally insulate them.
1.8

Safety information for commissioning

The transmitter is immediately ready for operation after mounting and installation of the
connections. The parameters are set at the factory.
The connected lines must be checked for firm seating. Only firmly seated lines ensure full
functionality.
1.9

Operating safety information

Before switching on, ensure that the specified environmental conditions in the "Technical
Specifications" chapter and in the data sheet are complied with and that the power supply
voltage corresponds with the voltage of the transmitter.
When there is a chance that safe operation is no longer possible, put the device out of operation
and secure against unintended operation.
8 - EN TTH200 CI/TTH200-EN